Usually the world watches strap factory are rather long. When to get a new lucury watches, the first step is to adjust the strap length and size. The most commonly used tool is the transfer table, and a hammer.

Bought a new world watches strap is too long, how to adjust it a little short? Today poly fashion just share with you how to use the transfer table to adjust the world watches steel strap length, go take a look.

Step / Method One:

1, the demolition of the table’s handle. Unscrew the thimble-shaped flat back to the edge!

2, a small card pin aligned to tear down strap between the world watches, the demolition of the table top and screw on the handle of the needle to a small card.

3, the world watches strap split the table into the “slotted” in the (needle card has two steel bolt is a flat one word has a slit word is so blunt tipped needle at one end of a card from the top not from the top end of a font)

4, adjusted according to the size of the wrist suitable length, then in the opposite direction of the arrow to the hands back together, installed the world watches strap but note that the world watches the strap must first determine the world watches with grain than by wire gong but by nails or hairpins loaded. May be taken from the mouth to the top of a large mouth that is OK! Hard to dismantle the strap only takes less than a minute when you can get!

Precautions

The thimble transfer table must be aligned with the world watches strap bolt, otherwise make the transfer table top is bad.

Transfer table is to avoid one’s strength inside twist, as this may lead to transfer table is scrapped.

Transfer table using step / Method Two

Usually the world watches strap factory are rather long. When to get a new world watches, the first step is to adjust the strap length and size. The most commonly used tool is the transfer table transfer table device, and a hammer, the following table is adjusted using the method:

1, compared to the world watches bracelet direction. Please look carefully before preparing the demolition strap on the back strap arrow, down arrow general world watches bracelet is the next big small, adjust the strap into the slot table, according to the aspect of the arrow, the alignment of the world bracelet watches pintle Confucius direction.

2, remove the nail table. Loosen the knob split the table, put the strap bad table, split the table and keeping the needle aligned strap pinhole, gently tighten the connecting strap needle will be pushed out. If the world watches long strap, it is recommended dismantling the same number the number of sections on both sides of the bracelet to ensure balance when wearing the watch.

3, reloading table nail. After the demolition of the world watches to fit the wrist strap size, first disconnect the strap connecting the two, then the second step did not go part way to the top of the needle into or struck with a hammer to! ( Note: when reassembling the strap, when the needle should be inserted preferably in the opposite direction of the arrow and select the needle is advanced one day, this will be easier to load).

Precautions

After reloading table staple, the world watches the demolition of the strap to the appropriate size of the wrist, first disconnect the two world watches strap connected, then the second step did not go part way into the top of the needle or can be struck with a hammer.